This article will show you how to unplug the Bitmain Antminer KA3‘s power supply step-by-step.
Read more: How to Use a Multimeter to Test PSU of Bitmain Antminer KA3?
Table of Contents
How to Remove the Power Supply of the Bitmain Antminer KA3
1. Tools
Phillips screwdriver or portable electric screwdriver.
2. Removing Steps
- The control panel cover and power supply cover can be opened by removing the screws indicated in the image below.
- To remove the top cover, press and hold the cover knob on the control panel while lifting up. Lifting the power supply up straight will allow you to remove the upper cover.
- The power supply voltage regulator line and the control board power supply line should both be unplugged after removing the copper bar screws.
- The power supply can then be slid out after the screws holding it in place have been removed.
- By sliding it to the end, the power supply can be taken out. Because the power supply is heavy, support it to prevent slipping and injury or damage to the device.
What Power Supply Does Antminer KA3 Use?
Antminer Power Supply APW12 for KA3 Connectors from Antminer. Read more about Antminer KA3 specifications.
The recommended input voltage is 220 V, using anything beyond 380 V will cause PSU damage.
Read more: Power Distribution Guide for Home Mining With Antminer KA3
Please feel free to contact us if you have any questions.
