The problem of entering the Bitmain Antminer KA3‘s backend but not finding any data will be discussed in this tutorial.
Abnormal Performance
can access the backstage area, but there is no data on the interface.
Reasons and Solutions
Here are three possible reasons and solutions:
- Either the settings are incorrect, or the network is broken. A BBitmain Antminer KA3’s interface is hidden when it is powered on and unable to connect to an outside network. Network errors are typically recorded in the log. It is important to make sure the network cable is connected to the external network correctly and that the Antminer KA3 mining pool‘s or IP settings are correct.
- withstand high temperatures. When the Bitmain Antminer KA3 starts, the temperature is high, so it is automatically protected; a notice of the high temperature protection can be found in the log. Increasing ventilation, adding exhaust fans, installing water curtains, and adding hot and cold insulation to the room can all help to solve the issue. Additionally, the problem can be solved by lowering the room’s temperature.
- The PIC is abnormal; ordinarily, the log would alert the user that the temperature is high, despite the fact that this is not the case. Repeated analysis has shown that the corrosion of the temperature sensor circuit is the typical cause of this problem, and that this corrosion needs to be corrected.
If you have any questions, don’t be afraid to contact us.
